be responsible for complex Piping calculations within the Department Mechanical
Engineering. You will be active in feeds, basic- and detail engineering and set up estimates for engineering activities in general.
Review Client's technical documentation and requirements.
Ensure an adequate standard of technical documentation and contribute in updating Company standards.
Review the Client’s technical documents during the bid phase.
Prepare the design basis/CTRs for the pipeline design and interface with the relative process and structures and installation.
Prepare the technical specifications and data sheets for material purchasing.
Check the results of surveys carried out by sub-contractors.
Optimize the laying route.
Assist with the selection of laying spread/methods and perform/review installation design analysis for the pipeline system.
Oversee the bid evaluation and procurements phases.
Compile the alignment sheets and design manual.
Verify and act upon the remarks of the Client/Certifying Body.
Skills & Requirements:
In Pipeline in oil & gas project/industry specially for onshore fields.
In project at all life-cycle stages of project development (FEED, Basic and Detailed Engineering, etc)
Oil & Gas Pipeline Materials, Design, Manufacturing and Testing according to industry standards and TotalEnergies specifications
International Pipeline codes
in Piping software & Piping vibration assessment (like PDMS/E3D, Caesar, etc)
in Sour Gas Service design
Standard expertise is required in: